Shenzhen HAISEN Technology Co.,Ltd.
SENSOR & SMART CONTROL
Add to Cart
DC Input 5.875GHz LED Motion Sensor Compact Size Easy For Install
DC Input Compact Size Easy For Install Dimmable Function Sensor
Features of Sensor:
1. Output: 5V PWM (Gradient)
2. With frequency of 5.835GHz-5.875GHz, there is no interference with the 5G Internet
3. Max. detection diameter of 10m with max. moungting height of 4.5m
5. All data are tested under the motion speed of 0.5~1m/s
5. Super compact size of 46*24.4*14.5mm, suitable for all kinds of LED light
6. 10 levels of brightness adjustment (10% for each pressing)
Product Description of Sensor:
| Control method | On/off / 5V PWM (Gradient) |
| Microwave frequency | 5.835GHz-5.875GHz |
| Operating voltage | 7-12VDC |
| Stand-by power | ≤0.5W |
| Package | Bubble pac,Cardboard compartments |
| Operating current | <30mA±5% |
| Microwave power | <0.3mW |
| IP grade | IP 20 |
| Operating temperature | -20°C~+60°C |
| Warranty | 5 years |
Mechanical structure of Motion Sensor:
| Detection area | Very near/Near/Medium/Far |
| Hold time | OFF/30s/10min/30min |
| Daylight threshold | OFF/ Over cast/Dusk/Night |
| Stand-by period | OFF/30s/10min/30min |
| Stand-by dimming level | Remarks: Stand-by dimming level is defaulted to be half brightness of hold time.Light dim down gradually until off. |
Dimensional drawing (Unit: mm) of Motion Sensor:
Compact size suitable for all kinds of lamps.
Wiring diagram of Motion Sensor:
| Control method | On/off / 5V PWM (Gradient) |
| Microwave frequency | 5.835GHz-5.875GHz |
| Operating voltage | 7-12VDC |
| Wire color | Red:VCC,Black:GND,White:PWM |
| Mounting height | Max. 4.5m/14.76 (ceiling mounted) |
| Detection range | Max.ø10m/32.8ft (ceiling mounted) |
| Detection angle | 30°~150° |
| Motion detection | 0.5~1.5m/s |
Installation of DC motion sensor:
3 pin connector,plug and plug,very easy to install and easy to use by end customer.
| Installation precautions of motion sensor | 1. Microwave sensor can be installed in any lamp except the one with full metal shell. |
| 2. The detected surface cannot be shielded by metal objects. | |
| 3. Make sure the microwave module is completely exposed outside. | |
| 4. The detection surface of the sensor module shall be installed facing the detection area. | |
| 5. Should be kept away from the driver to avoid interference generation and lamp flashing. | |
| 6. Wiring must be strictly in accordance with the wiring diagram to avoid short circuit. |